DIYables 2WD RC Robot Car Kit with L298N Motor Driver and Sensors for Arduino, ESP32, ESP8266, Raspberry Pi
Click to zoom
Quick Overview
The DIYables 2WD RC robot car kit is a practical starter kit for learning robotics and building your own two-wheel-drive robot car. It combines a 2WD chassis with an L298N motor driver and common sensors, making it a good platform for obstacle avoidance, distance measurement, and motor control experiments.
The kit includes:
- 1 x RC 2WD Car Kit with Motor Speed Encoder
- 1 x Battery Holder
- 1 x L298N motor driver
- 1 x Ultrasonic Sensor HC-SR04
- 1 x Infrared Obstacle Avoidance Sensor Module
Use it with Arduino, ESP32, ESP8266, or Raspberry Pi controllers to create a remote-controlled car, a line/obstacle-avoidance robot, or a sensor-driven autonomous vehicle prototype.
Key Features
- Complete Robot Car Kit — Includes 2WD chassis with motor speed encoder, battery holder, L298N motor driver, HC-SR04 ultrasonic sensor, and IR obstacle sensor
- Easy Assembly — Simple installation with an install guide
- Double-Layer Chassis Support — Supports a double-layer chassis configuration
- Mounting Options — Includes mounting holes for a 5-AA battery setup and a 2-lithium battery setup
- Speed Sensing Ready — Two speed disk holes can be used with a speed sensor
- Motor and Drive Specs — Uses 130 anti-jamming magnetic torque motors; voltage 3~10V; transmission ratio 1:48
- Chassis Dimensions — Chassis length 22cm; two-wheel width 17.5cm; head width 15.6cm; middle width 12cm
- Current Notes — At 7.2V: idle current about 130mA; ground running current around 200mA
- Material — Acrylic
SPECIFICATION
| Specification | Value | |
|---|---|---|
| Product Type | 2WD RC Robot Car Kit | |
| Motor Driver | L298N | |
| Ultrasonic Sensor | HC-SR04 | |
| Obstacle Sensor | Infrared obstacle avoidance sensor module | |
| Motor Type | 130 anti-jamming magnetic torque motors | |
| Motor Voltage | 3~10V | |
| Transmission Ratio | 1 | 48 |
| Material | Acrylic | |
| Chassis Length | 22cm | |
| Two-Wheel Width | 17.5cm | |
| Head Width | 15.6cm | |
| Middle Width | 12cm | |
| Current (7.2V idle) | About 130mA | |
| Current (running) | Around 200mA |
Tutorials
COMPATIBLE HARDWARE
This 2WD robot car kit is compatible with:
- Arduino Uno R3
- Arduino Uno R4 WiFi
- Arduino Nano
- Arduino Nano ESP32
- Arduino Mega
- ESP32 Development Board
- ESP8266
- Raspberry Pi
- Raspberry Pi Pico
- Additional Sensors and Modules
- Servo Motors
- LED Modules
